
Steel Tape Armoured Cable, 0.6/1kV
0.6/1kV XLPE cable with a galvanised steel tape armour over a PVC bedding, finished with a PE or PVC sheath for buried and exposed routes.
Construction and behaviour
Steel tape armour is the standard answer to a route that cannot be protected by ducting. Two galvanised tapes are applied helically over the cable bedding, overlapping so that the layer is continuous, and then covered by an extruded sheath. The result resists impact, compression and rodent attack, and provides a metallic earth path along the route.
The bedding matters as much as the armour. It cushions the tapes against the insulation during bending and prevents the tape edges from damaging the cores. A cable that skips the bedding may pass a factory test and still fail after a few years in wet ground.
Double tape (DSTA) is used where the specification calls for higher impact resistance or where the tape thickness would otherwise be insufficient for the required short-circuit rating. Single tape is adequate for ordinary burial depths and normal traffic loads.
Sheath choice follows the soil: PE for permanently wet, sandy or chemically active ground, PVC ST2 where flame retardance or UV exposure governs. Black is standard; the sheath carries embossed or inkjet identification along its length.
Specification table
| Standard | IEC 60502-1, IEC 60228 |
|---|---|
| Rated voltage | 0.6/1 kV (U0/U) |
| Conductor | Class 2 stranded copper; aluminium on request |
| Cross-section | 4 – 400 mm² |
| Insulation | XLPE (90 °C) or PVC (70 °C) |
| Bedding | Extruded PVC or PE inner covering |
| Armour | Galvanised steel tape, single or double layer |
| Outer sheath | PE or PVC ST2, black, 1.8 – 3.0 mm nominal |
| Bending radius | 12 × overall diameter (tape armour) |
| Application | Direct burial, cable trench, outdoor yard, duct |
| Packing | Drum, 500 m / 1000 m or project lengths |
Available constructions
| Construction | Typical use |
|---|---|
| Cu / XLPE / STA / PE | Direct burial in wet or chemically active soil. |
| Cu / XLPE / DSTA / PE | Higher impact resistance, deeper burial, vehicle loading. |
| Cu / XLPE / STA / PVC | Buried or exposed routes where flame retardance is also required. |
| Al / XLPE / STA / PE | Long feeders where weight and cost matter. |
Where it is used
- Buried feeders — Workshop, pump house and site building supplies without ducting.
- Outdoor yards — Routes crossing vehicle areas, storage yards and exposed ground.
- Cable trenches — Shared trenches where later works may damage an unarmoured cable.
- Ring mains — Site distribution rings with multiple buried sections.
How it ships
- Drums marked with cable description, length, drum number and gross weight.
- End caps sealed against moisture ingress during sea freight.
- Drum schedule and packing list issued with the shipping documents.
- Armoured glands and earth tags can be supplied with the order.
Request datasheet & price
Send the project specification and we will confirm construction, standard and delivery schedule. Samples for approval can be arranged.
Get a Quote WhatsApp UsQuestions buyers ask about this cable
How deep should armoured cable be buried?
Can the armour be used as the earth conductor?
Does the cable come with glands?
Is STA cable suitable for a vertical riser?
Request datasheet & price
Send the project specification and we will confirm construction, standard and delivery schedule. Samples for approval can be arranged.
Get a Quote WhatsApp UsOften specified with this cable
Related constructions from the same or a neighbouring family.
All products
0.6/1kV PVC/XLPE Insulated LV Power Cable
The general-purpose 0.6/1kV cable for final circuits: copper conductor, PVC or XLPE insulation, 1 to 5 cores, PVC, PE or LSZH sheath.
View product →
Aluminum Conductor LV Cable
0.6/1kV aluminium conductor cable for long feeders where weight and cost matter: XLPE insulation, 16 to 400 mm², PVC or PE sheath.
View product →
LSZH Flame Retardant LV Cable
0.6/1kV XLPE cable with a halogen-free low-smoke sheath, tested to IEC 60754 and IEC 61034 for tunnels and public buildings.
View product →Request a quotation for Steel Tape Armoured LV Cable
Share the application, voltage, core count, conductor size, screen or armour, sheath and delivery destination. Our engineering team replies within one business day.
